The emergency brake toggle lever has originally no grease fitting. The same is with
the toggle lever at the emergency brake handle. I supported them both with grease fittings.
|
I have drilled a 4mm hole into the axle. In the middle of the axle I drilled a second hole
which goes from outside until the center of the axle and let the grease come out. At the
position where the grease fitting is mounted, I have enlarged the hole until I could
press in the fitting. Be careful when you press in the fittings, you should use a special
tool for that, otherwise you'll destroy them when you are using just a hammer.
|
These parts are new, since the old ones were completely destroyed by rust. Source: http://www.maurer-markus.ch/ford_a/mod_schmiernippel.en.html |
Focused on the Ford Model A Manufactured between 1928 and 1931, Henry & That Era
No comments:
Post a Comment